How to add (more) sensors in MSM

Document ID

Document ID TE10740

Published Date

Published Date 11/19/2018
How to add (more) sensors in MSM
Adding a sensor or more sensors in MSM is very easy and intuitive. Follow these steps in how to proceed

1. Make sure that the controller is provisioned and connected to the HACH Server.
2. Verify that the controller is online on the device list.
3. Physically connect the sensor to the controller.
4. Wait approximately 30 seconds, then refresh the browser.
5. Click on ADD DEVICE 
6. Verify that the correct serial number, image and the correct measurement parameters of the sensor are shown.

7. The sensor is online on the device list and the device details page.
6. After approximately 30 seconds, the measurement values are updated for all devices.

Was this answer helpful?

Thank you for your feedback!
There was an error with your submission. Please try again.