Is there a fixed point mounting kit for the LDO Model 2 or the Differential pH (pHD) sensors?

Document ID

Document ID TE4269

Version

Version 2.0

Status

Status Published

Published Date

Published Date 06/06/2019
Question
Is there a fixed point mounting kit for the LDO Model 2 or the Differential pH (pHD) sensors?
Summary
Part configuration and options for fixed point mounting hardware for both the LDO Model 2 sensor and the pHD sensors.
Answer
Please see below information for fixed point mounting installation (Product # LZY370):
 
 

 
 
NOTE - The following part numbers have been changed:
 
  • LDO pole with adapter: Product # 579-095EUNF is the pole with the adapter {Product # 8813400 } included.
     
  • pHD pole and adapter: Product # 1000F3407-00882  is the pole. Product # 3P2120-132 is the adapter (reducing coupler 11/2"-1") for the pHD, and Product # 1P2116-107 is the end cap. Product # 1H1203 is the grommet.
 
However there is an alternative mounting bracket. It is used with the Evita product line and you could use it with all of the parts listed above. Product # 085G4085 is a wall mount bracket. There is one drawback, it does not stick out from the wall and has a limited tilt (see below). You would have to either place it at the top of the wall for maximum tilt or slide the pole all the way down for maximum tilt. Customer has a choice on what is best for their situation.

Was this answer helpful?

Submitting...
Thank you for your feedback!
There was an error with your submission. Please try again.