What could cause hardware errors right out of the box for a new 5500sc Analyzer?

Document ID

Document ID TE1902

Published Date

Published Date 03/03/2018
Print
Question
What could cause hardware errors right out of the box for a new 5500sc Analyzer?
Summary
5500sc analyzer Installation hardware errors.
Answer
Hardware errors at installation on a 5500sc analyzer can be caused by a wiring connector coming loose. Check the wiring connections on the back of display board and make sure that each one is seated securely then restart the analyzer.
If the cable ties holding the wires together are too tight, the connections may become loose every time the door is opened.  If this is the case, remove the cable ties and reinstall a new set of cable ties a bit looser. 

Was this answer helpful?

Submitting...
Thank you for your feedback!
There was an error with your submission. Please try again.