Is there general guidance for creating the most accurate calibration curve for suspended solids?

Document ID

Document ID TE751

Version

Version 4.0

Status

Status Published

Published Date

Published Date 09/13/2018
Question
Is there general guidance for creating the most accurate calibration curve for suspended solids?
Summary
TSS portable suspended solids curve recommendations
Answer
Hach recommends selecting a calibration point with a value in the upper third of the range expected. Start with a single point calibration in that range. In case a single point calibration is not sufficient, the error "message Calibration insufficient" or "Calibration insufficient +" will guide you to set up an appropriate curve, thus will provide a more accurate measurement.

Was this answer helpful?

Submitting...
Thank you for your feedback!
There was an error with your submission. Please try again.